Filter
Top Products
Tape Operation
33
Tape Operation
Rec End Search
This feature allows you to quickly find the point at which your recording
ends and a blank portion of tape begins for continuous recording.
In play, FF or stop mode, press the Rec End Search button on the remote
control. The TV/VCR Combination will go into FF mode and then stop
automatically around the end of your recording.
If the Rec End Search button is pressed where no signal is recorded, the
TV/VCR Combination will go into rewind mode and then stop automatically
around the end of your recording.
Before starting recording, play back the tape to determine where to start
a new recording.
"REC END SEARCH" will appear on the TV while the search is in
progress.
Time Search
The time search feature lets you enter a length of time to skip back or
ahead. When the selected search length is completed, the TV/VCR
Combination will automatically go into playback mode.
1 Press the Time Search button on the remote control in the stop or play
mode.
This selects the time search display.
2 Enter one digit for the hour, two digits for the minute. This enters the
length you want to skip back or ahead.
For example, for 1 hour 25 minutes, press 125.
For 5 minutes, press 005.
3 Press the FF or REW button to skip back or ahead.
The TV/VCR Combination will skip over the desired length of time and go
into playback automatically.
Make each key entry for your length selections within 10 seconds, or the