Filter
Top Products
Tape Operation
34
TV/VCR Combination will automatically cancel this mode.
Auto Play with Repeat Function
Picture of Remote Buttons
1 Press the Repeat button during playback, still, search, or slow.
a) The Repeat indicator appears. Playback will continue to the end of the
tape unless there is more than 30 seconds of blank space on the tape.
Erased portions of tape are not considered to be blank.
b) When playback stops, the tape will automatically rewind to the
beginning. During rewind, if the channel you selected through the TV/VCR
Combination tuner is not tuned to an active channel, a blue background
will be displayed.
c) Playback will begin again and continue to the same point where the first
playback stopped and continue to repeat to that point until another
function button is pressed.
2 To release the auto repeat, press the Repeat button again. You can also
press another button to stop repeat playback.
The Counter memory does not function during auto repeat.
Time Counter Control
If your tape is fully rewound each time, then you can reset the counter to
use a list of program locations as an index. You can also reset the counter
at any location, and use it to return to that location for repeat playback. Be
sure the time counter overlay is displayed when you use the time counter.
To remove an overlay, press the Recall button again. (See "VCR Status
Display" on page 8 for more information.)
1 To select the time counter overlay, press the Recall button once or
three times. The time counter display appears on the TV screen.
2 To reset the time counter, press the Reset button. Reset the counter to
zero at whatever point you choose on the tape.
3 To select the memory function, press the Memory button. Select
memory during any operation with the time counter overlay showing.