Filter
Top Products
30
USING THE REMOTE TO CONTROL CABLE/SATELLITE
BOX FUNCTIONS
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match
the remote system in your cable/satellite box. (Refer to page 31.)
1. Turn on your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. Press the CABLE button to switch to cable/satellite box mode.
4. While holding down the CABLE button, enter the two digit preset code that matches your cable/satellite box as shown on page
319. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the
remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try
another two digit preset code.
5. The remote will now control your cable/satellite box.
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box code has not
been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult
your cable/satellite box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the remote control.
After replacing the batteries, repeat the entire programming procedure stated above.
4. If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP (̆) function.
ᕃ CABLE Button
This button allows the remote to control your cable/satellite box by setting it to CABLE/SATELLITE mode.
ᕄ PRECODED CABLE/SATELLITE BOX Buttons
These buttons transmit the chosen precoded CATV and satellite codes.
ᕅ EXCLUSIVE PC ready color TV Buttons
These buttons are for operating the PC ready color TV.
ᕆ LST-CH Button
If your cable/satellite box has an enter function, this button will send the cable/satellite box enter code.
ᕇ SLEEP Button
If your cable/satellite box has a +100 function, this button will send the cable/satellite +100 code.