Filter
Top Products
and PIP sub-picture tuning, press PIP CH button on the remote. Every press of the PIP CH will highlight the
main or sub-PIP source. The top channel display is the main picture and the bottom display is the sub-picture.
This method of picture tuning is the same for one antenna input (ANT A only) and two antenna inputs (ANT A and
ANT B)
The Picture-in-Picture feature is convenient when you want to watch more than one program at the same time.
You can watch a TV program while viewing other programs from the ANT A source or any of the video inputs.
(1) PIP button
Press the PIP button and a sub-picture will appear in one of the two different modes (SINGLE or SURF),
depending on the last selection of the PIP mode. To change the PIP mode use the CURSOR
or buttons
and the new selection will appear the next time the PIP function is used.
SINGLE MODE PIP
Press the PIP button and a sub-picture appears in one corner of the screen. Press the button again to reduce the
size of the sub-picture. Pres the PIP button a third time to remove the sub-picture from the screen. Use the PIP
CH button to select between main and sub-picture tuning control (indicated by highlight). Press the INPUT button
when a sub-picture channel tuning is being controlled, to change between VIDEO: 1, VIDEO: 2, and ANT A
antenna source. (ANT B source cannot be viewed as a sub-picture and COMPONENT: Y-CB-CR Input 2 source
will be displayed as a blank sub-picture).
NOTE:
Since ANT B source cannot be viewed as a sub-picture, only SINGLE PIP mode is possible when ANT B is
selected as the main channel.
When the COMPONENT VIDEO: Y-CB-CR Input 2 is selected as PIP, it will appear as a blank sub-picture.
SURF MODE PIP
This feature will automatically scan all active channel numbers (those set in memory) and display them as PIP
sub-pictures, along the right edge of the screen. Press the PIP button a second time to remote the sub-pictures
from the screen.