Filter
Top Products
STROBE FREEZE
Press the FRZ button to freeze four frames of the picture you are currently viewing. Press this button again or
PIP to return to normal viewing. This feature is useful for viewing a moving picture that has many details, for
example, a close play in a sporting event of golf swing.
CAUTION: A pattern burn may develop if the Sub-Picture is left in the same corner permanently. If the
PIP feature is used frequently, occasionally MOVE the Sub-Picture to a different corner. You may also vary its
position using the CURSOR , , , or buttons.
NOTE:
1. Only sound from the main picture can be heard.
2. Each freeze frame is delayed about 0.1 (1/10) second.
3. The FREEZE function will display blank sub-pictures when the COMPONENT VIDEO: Y-CB-CR INPUT 2
source is set as main channel.
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote system of your
VCR
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the VCR button to switch to the VCR pre-coded mode.
4. Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR as shown on
page 27. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs,
the remote control is programmed for your VCR. If the VCR does not turn off after five seconds, try a different two
digit preset code.
5. The remote will now control your VCR.
* If you wish to control a DVD player, you must follow the remote programming procedure shown above. You may
use only the VCR button to program these codes, but note that this button may not be used for more than one
component.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR's code has not been precoded into the
remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR
operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.
After replacing the batteries repeat the entire programming procedure as stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
5. The MENU button will act as the VCR MENU button for HITACHI VCRs.
6. The LST-CH button will act as your VCR ENTER button if required.
7. The SLEEP button will act as your VCR '100' button if required.