Filter
Top Products
(1) VCR Button
This button allows the remote to control your VCR by setting it to VCR mode.
(2) PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button
twice to record a program.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE
FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote system
cable box. (Refer to page 27.)
1. Turn ON your cable box.
2. Aim the remote control at the front of your cable box.
3. Press the CABLE button on the remote to switch to cable mode.
4. Hold down the CABLE button on the remote, enter the two digit preset code that matched your cable box as
shown on page 27. The remote will turn off your cable box when the correct two digit preset code is entered.
When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after
five seconds, try another two digit preset code.
5. The remote will now control your cable box.
* If you wish to control a Satellite system or Audio equipment, you must follow the remote programming procedure
shown above. You may use only the CABLE button to program these codes, but note that this button may not be