Filter
Top Products
- 36 -USING
THE GENIUS REMOTE TO LEARN ADDITIONAL
2. Set the LEARN/USE mode select switch located on the back of the Genius Remote
to the LEARN position.
3. Set the MULTI-PAGE select switch to "USER" position.
4. Press one of the learnable buttons on the Genius Remote, ("7" in this example). This
button will be used to store the new code. The READY indicator will flash at this time.
(The light will remain lit for approximately 15 seconds. If no other function is performed
at this time, the operation is canceled.)
5. Press and hold the button down on the other transmitter which contains the code to
be stored, while the READY light is lit.
Release the button after both the READY indicator goes out and the LEARN indicator
lights.
When storing has been performed correctly, the LEARN indicator lights for about 2
seconds.
If the storing was not done correctly, or the codes are too long to learn, or no more
codes can be stored in memory due to memory overflow, the LEARN indicator will not
light.
6. Set the LEARN/USE mode select switch on the back of the Genius Remote to "USE"
and check that the button to which the code is stored operates correctly.
If it does not operate correctly, repeat from step 1.