Filter
Top Products
- 38 -CARE
OF YOUR PROJECTION TV AND REMOTE CONTROLS
Caution on batteries
• The Genius Remote Control is working when the LEARN indicator lights up when a button
is pressed.
• When you press a button and the learn indicator will not light up or if the operation is
extremely slow, this is an indication that the batteries should be replaced.
• Even if the batteries seem dead, do not remove them until you have replacement batteries
ready to put in. The codes stored in memory will be erased in a few minutes without power.
When replacing batteries, prepare the new ones first.
CARE OF YOUR PROJECTION TV AND REMOTE CONTROLS
DO
• Dust the screen and cabinet with a soft cloth.
• Clean the screen with a soft cloth moistened in warm water. Dry with a soft cloth. (A
mild soap may be used if the screen is extremely dirty.)
• Place your TV and remote controls away from extreme heat, humidity and extremely
dusty places.
• Remove the plug from the wall outlet if your television set will not be used for a long
period of time, for instance, when you go on vacation.
DO NOT
• Do not clean your screen or cabinet with strong cleaners, polishes or chemically
treated cloth.
• Do not place rubber or vinyl products or cellophane tape on your set.
• Do not touch the screen too often.
• Do not subject the Remote Control to shocks such as dropping it on the floor, etc.
Physical damage to the precision parts may result.
• Avoid placing the Remote Control in a high humidity place or getting it wet. Don't leave
it on or near a heater. Excessive heat or moisture may cause the unit to cease
operation.
• When the batteries run down, remote control operation will become erratic or possibly
stop altogether. Replace the old batteries with two fresh "AA" size batteries for either
the Genius remote or the Easy remote.
• Exposure of the viewing screen to prolonged direct sunlight or heat may cause the
screen to permanently warp, resulting in a distorted picture.