Filter
Top Products
- 37 -USING
THE GENIUS REMOTE TO LEARN ADDITIONAL
7. Repeat steps 3 to 5 to store other keys.
8. This Remote transmitter also provides a function to clear the remote control codes
which have been stored.
To clear the stored codes from the USER mode.
Set the MULTI-PAGE select switch to the USER mode and LEARN/USE mode select
switch to "LEARN". Then, press the POWER and the MUTE buttons simultaneously for
3 seconds. The "READY" and "LEARN" LEDs will light together. All MULTI-PAGE KEYS
with codes are reset to their initial states.
To remember stored codes, it is convenient to paste the labels (user's label) provided
on the buttons for the USER page. If the correct labels are not provided, it is possible to
write these letters on an empty label with a ballpoint pen.
Example of User's Labels
NOTES
1. To operate your TV, be sure to point the Genius Remote at the remote sensor on the
television. To operate other electronic equipment like a VCR, point the remote at the sensor
on the device.
2. Refer to the instruction manual of the VCR for operation on the buttons exclusively for
the VCR.
3. Be sure to keep the original remote transmitter even after storing its codes in the Genius
Remote Control.
If the Genius Remote is left with its batteries removed, the learned codes in its memory are
erased and will have to be reprogrammed into the memory.
4. The Genius Remote Control may not be able to learn certain special remote codes.