Filter
Top Products
19
ENGLISH
When the TV powers on for the first time after purchase, the initial auto installation menu will appear. You can
automatically set language, country and channels in successive operations.
1. Press STANDBY
on the right side of the unit or press (STANDBY) on the remote. The Language select menu will appear
first.
2. Press ϳ/ϴ or ϵ/϶ to select desired language. Then press ENTER.
3. Press ϳ or ϴ to select desired country. Then press ENTER.
4. Check the aerial then press ENTER.
5. Press ϳ or ϴ to select the colour system.
6. Press ENTER to start automatic tuning.
Your TV will now automatically tune in all available channels.
NOTE
Please be patient - the Auto Tuning process can take several minutes to complete.
When the tuning screen disappears and then normal TV screen appears, the Auto
tuning process is complete.
NOTE
The initial auto installation functions only once. If the initial auto installation is not completed, try AUTO TUNING
25
.
To cancel the Auto Tuning, press EXIT during the process.
If the received signal for some channels is too weak, the automatic tuning system may not pick them up - in this case you may
need to use manual tuning
25
.
If you want to reconfigure the country setting, for instance after moving to another country, conduct “AUTO TUNING” from the
Menu again.
•
•
•
•
BASIC OPERATION
Auto setup
Turning on the power
Press on the TV.
The
indicator on the TV changes from red to green.•
Standby mode
Press on the remote control when the TV is on.
The TV enters standby mode and the image on the screen
disappears.
The
indicator on the TV changes from green to red.
You can turn the TV on by pressing
on the remote control
from standby mode, or press CH ϳ/ϴ on the TV or P+/- on the
remote control.
Weak electric power is still consumed even when
is turned
off.
To completely turn off the TV, press
on the TV.
•
•
•
•
•
Press
to view a signal from another device connected to your TV, such as a VCR or DVD player. You
can select each input source depending on which input jacks you used to connect your devices.
To select the video input source, press ϳ/ϴ or the corresponding number button. Then press ENTER
within 6 seconds.
Selecting the video input source
[ 0 - 8 ]: SELECT
SOURCE SELECTION
0.TV
1.AV1
2.AV2
3.AV3
4.AV4
5.COMPONENT
6.HDMI1
7.HDMI2
8.PC
:SETENTER
Display status indicator
Off Power off
Red The TV is in standby mode.
Green The TV is on.
NOTE
If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the power outlet.
:SELECT
:SELECT
: END
EXIT
:SET
ENTER
LANGUAGE
English Dansk
Français Norsk
Deutsch Nederlands
Español ǏǸǸdzǺǶǷȉ
Italiano Türkçe
ȥɜɚɚɓɑɒ Português
Svenska Polski
Suomi
Downloaded From TV-Manual.com Manuals