Hitachi P42A01 TV Antenna User Manual


 
21
ENGLISH
BASIC OPERATION (continued)
Conceal stored channels
Picture format
Press , then press ϳ or ϴ to select desired picture format, then press ENTER.
AUTO
Automatically selects the aspect ratio (see note below).
NOTE
In case a screen switches with AUTO operation, the screen may become black for a moment according to
the conditions of a weak-electric-field and an input signal, but it is not a failure.
4:3
It shows a 4:3-picture in original size with grey bands on left and right side.
FULL
Stretches the left and right hand sides of a 4:3 picture horizontally to fill the screen, while leaving
the centre of the picture unstretched.
NOTE
In this mode the picture is geometrically distorted on the left and the right sides of the screen.
PANORAMIC
This mode is used with 16:9 signals from a Digital decoder, a DVD player or other external
source. This uniformly stretches a 4:3 image horizontally to fill the screen (For example, a 16:9
image is often stored “anamorphically” on a DVD, where the 16:9 image is stored as a horizontally
compressed 4:3 image - this mode restores the image to its correct 16:9 proportions).
ZOOM
This mode is used to zoom-in on (expand) 4:3 “letterbox” format pictures (with grey bars at the top
and bottom) so that they fill more of the screen.
NOTE
In the ZOOM mode, part of the picture may be slightly cut off due to the expansion. However, it is possible to scroll the picture up or
down to view the top or bottom part of the picture
26
.
14:9
This enlarges a 4:3 picture to the 14:9 format.
NOTE
When the Picture format is set to AUTO, the aspect ratio will automatically change according to the Wide Screen Switching (WSS)
signal, if it is available. This may be either transmitted by the broadcasting TV channel, or via a recording from a VCR etc. Any WSS
signal received will only be effective in the AUTO mode - however, some DVD players / Digital Decoders etc. will automatically
switch the aspect ratio via the SCART input (Pin 8 switching), even if AUTO is not selected. In any case if you want to change to a
different aspect ratio to the one selected automatically, you can change it by pressing
.
In PC mode, the Picture format is available only for 16:9 or 4:3 format. (In “WXGA INPUT” and “WVGA INPUT” mode, the Picture
format is not available.)
In HDMI or COMPONENT mode of scanning rate: 720p and 1080i, the Picture format is available only for FULL1, FULL2 and
ZOOM format.
SUBTITLE SUBTITLE
SUBTITLE SUBTITLE
You can conceal certain channels so that when you use the P+ or buttons they are skipped.
In this case these channels are not deleted - they can be accessed at any time using the 10 Number Buttons.
1
Select the channel to be concealed (i.e. CH29).
Press SKIP. The programme number flashes.
2
Select the next channel to be concealed.
Press SKIP. The programme number flashes.
You can conceal as many channels as you like.
Cancel concealment of channels
Select the concealed channels with the 10 Number Buttons.
The programme number flashes.
Press SKIP. The programme number no longer flashes.
This channel is no longer concealed.
(FULL)
(PANORAMIC)
(ZOOM)
(14:9)
[0-5 ] : SELECT
PICTURE SIZE
0.AUTO
1.4:3
2.FULL
3.PANORAMIC
4.ZOOM
5.14:9
:SETENTER
Downloaded From TV-Manual.com Manuals