Filter
Top Products
PROBLEM GUIDE / MAINTENANCE - 79 -
PROBLEM GUIDE / MAINTENANCE
Problem guide
No power
• Make sure the VCR is plugged into an AC outlet.
Remote control doesn't
work
• Make sure the batteries are fresh, and properly
installed.
Won't record
• Safety tab has been removed from cassette (VCR
will
automatically eject the tape).
Won't play back
• Make sure the TV/VCR switch is set to the VCR
mode.
• Make sure the TV is set to the VCR channel (3 or
4) or AUX (if
using direct audio/video hookup).
Won't make timer
recordings
• The VCR power must be turned off to activate
timer recording.
• Clock is not set correctly.
• Programs entered incorrectly.
• Programs exceed the length of the cassette. Use
the EP
recording speed for maximum programming.
• Safety tab has been removed from cassette.
Snowy picture in playback
• Snow or picture noise is normal during search,
still, and slow
Playback.
• Head cleaning may be required.
• Tape is worn or of inferior quality - adjust tracking
controls.
Snowy picture in normal
TV viewing
• Check antenna or cable connections.
Clock shows --:-- on the
TV display
• Power has been interrupted - reset the clock.
• Reset the clock.
Erratic VCR display
• Push the reset switch with a sharp pointed
instrument (pen, toothpick, etc.).
Maintenance
Regular periodic maintenance is required to maintain optimum VCR performance. Such maintenance and
adjustments should not be attempted by the user. Please consult your service dealer for further information.
NOTE: Dirt accumulation on the video heads will cause the playback picture to become noisy. The VCR may
require the video heads to be professionally cleaned by a qualified service dealer.