Filter
Top Products
PRE-TUNING THE VCR TUNER
Note: An antenna or cable must be connected to the VCR before you begin this operation.
Presetting the received channels without using a cable box
(Hookups [A], [B], [C], or [D])
Press the POWER button to turn on the VCR.
1 Turn on the TV and select the video channel (3 or 4).
Or, if you are hooked up with an audio/video cable, set the TV to AUX or VIDEO.
2 Press the GUIDE button.
The main on-screen menu will appear on the TV screen.
3 Press the
cursor button to select the SETUP option, and press the ENTER button.
4 Press the
cursor button to select the CHANNEL, and then press the ENTER button.
5 Press the
cursor button, and then press the ENTER button.
The VCR will automatically select CATV1 or ANT and store channels received in your area. It takes about 2 - 3
minutes.
If CATV1 doesn't give you the channels you expect, press the
cursor button to select CATV2 at step 4.
After the channels are stored in memory, the channel with the lowest number appears in the VCR's display.
6 Press GUIDE to return to regular viewing.