Filter
Top Products
Note: Refer to the cable box owner's manual to identify the cable box output channel (usually 3 or 4).
8 Press the cursor button to select "VCR PLUS+ SETUP", and then press the ENTER button.
9 Press the ENTER button to answer "YES" to the question "IS CABLE BOX BEING USED?"
Or, if you want to select "NO", press the
cursor button and then the ENTER button.
• If you select "YES", you need not operate "VCR PLUS + SETUP" . During delayed recording, the VCR channel
will automatically switch to the cable box output channel.
10 Using the VCR remote, press the
or cursor button to enter the cable box output channel
numbers.
11 Press the GUIDE button to end this setting.
The cable box output channel has now been set. However, the VCR does not control your cable box. Turn on the
cable box and leave it tuned to the channel you want to record before the recording is scheduled to begin.
Note: If you make a mistake when entering digits, press the REW button to return the white dash "---". Then,
press the or cursor button to enter the correct number.