Filter
Top Products
Honeywell 301C User Manual
System Programming
The system’s Normal programming mode offers several menu options
that are accessible from the main menu screen:
1. Tx Info:
Allows transmitter parameters to be programmed
2. Groups:
Allows sets of multiple transmitters to be aggregated
for simpler programming of a common response.
3. Events:
Facilitates creation of logical terms which respond to
transmitters or events. These Boolean outputs can
respond to concentration, alarm, or fault status. These
events facilitate voting within a group and can drive
relay outputs.
4. Acqui:
Allows the datalogging feature to be activated or
deactivated
5. Copy:
Allows data or parameters to be copied from the
(controller) configuration to parameters
6. Config:
Allows system parameters and password to be set
7. Network:
Allows actions on the network to be performed,
communication statistics to be consulted, and remote
calibrations to be performed
8. Tests:
Allows each device to be tested sequentially (inputs,
outputs, communications, events, etc.) and operation
of various parameters to be validated
9. BACNet:
Allows a device’s BACNet parameters to be set
10. Wireless:
Not supported.
Note: Access to the programming functions is password protected.
The default password is 2967.
The screen display shown below appears initially. This display can be
configured to scroll among the information screens for each device
connected to the controller.
If one or more of the connected devices is in an alarm mode, the
controller will only scroll between the main information screen and the
19