Filter
Top Products
Rev 1.00 34 Document 900.0259
10/04
Operation
P
Front Panel LEDs
Under the following conditions, the red light is ON:
• HDD = The hard drive is activated.
• HDD FULL = The hard drive is full.
• ALARM = When alarm enable is set to Yes and an alarm is triggered, the LED
flashes red.
• TIMER = When timer enable is Yes
• PLAY = The HRTL-One is in Play mode.
• REC = The HRTL-One is in Record mode.
Powering Up the HRTL-One
Before you power up the HRTL-One, make sure the hard drive is locked (key lock is in A
position) and the POWER LED (above the POWER button) is red.
Press the POWER button. You will notice:
The POWER LED turns orange, then all the other LEDs turn red, except the HDD
LED.
The On-screen Display (OSD) shows the message
HDD Detecting
.
The powering up process takes approximately five to 15 seconds. During power up, if the
HDD is set as Master, the message on the OSD is
HDD Master Connect
. If the HDD is
set as Slave, the message on the OSD is
HDD Slave Connect
.
Note If the hard drive is set as Slave, change the jumper settings so that the hard
drive is set to Master.
When the powering up is complete, the POWER LED turns green.