Filter
Top Products
DiSEqC 1.2 User Instructions
If you have a DiSEqC 1.2 motorised system, you can use the available DiSEqC 1.2 functions.
The following instruction describes how to use the DiSEqC 1.2 functions to store the positions of the
satellites and search for the services (STAB Rotor Sat motor recommended).
When the DiSEqC Motorised System is Enabled in the Antenna Setting, a new menu is available for
configuring the motor. This menu is called “Satellite Setting” and is accessed by pressing the OK
( ) button with the Alternative Antenna option highlighted in the Manual Search menu.
The following options are available on the Satellite Setting menu:
Satellite Name
A selection of satellite names that can be used to identify a motor position. If the satellite name you
require is not available, please use another one. In installer mode, the Satellite Name Reference
refers to the 0 position of the motor.
Movement
In user mode, this is used to fine-tune the position of the motor for better reception.
In Installer mode, this is used to manually search for the position of a satellite.
Motor Control
• Search: Searches for services on the chosen transponder.
• Goto: Moves the motor to the stored position of the selected satellite name.
• Store: Stores the current position of the motor for the selected satellite name.
• Reset: Resets all stored positions of the motor relative to the 0 position (Installer mode only).
DiSEqC Command Mode
Changes the current mode between Installer and User.
You must set your receiver up so that it is ready to use DiSEqC 1.2. To do so, proceed as follows:
1. Press the MENU ( ) button to display the Main menu.
2. Select the Service Searching option and press the OK ()
button to display the Service Searching menu.
3. Select the Antenna Setting option and press the OK ()
button to display the Antenna Setting menu.
4. You must set up a separate alternative antenna for each
satellite position required.
5. Select the name of the satellite you wish to use.
6. Select the correct LNB frequency for the LNB you are using.
7. Set the Motorised System to Enable to use the
buttons.
8. The option DiSEqC Input Selection should now be disabled. This option is used for DiSEqC 1.0
and cannot be used in conjunction with DiSEqC 1.2. Your receiver is now ready to use DiSEqC
1.2. To return to the Main Menu, use the EXIT () button until you reach the Main menu.
2. Setting your Receiver for DiSEqC 1.2
1. Satellite Setting Menu Options
Motorised System
GB46