Filter
Top Products
ixfp report
AR 0015 SUBSYSTEM 1321117
AR 0015 *** DEVICE DETAIL REPORT ***
AR 0015 <---FUNC. CAPACITY (MB)---> <---CAPACITY (%)---> PHYS. COMP.
AR 0015 CUU DEF ALLOC STORED UNUSED ALLOC STORED UNUSED USED(MB) RATIO
AR 0015 80E 2838.0 N/A 392.9 2445.1 N/A 13.84 86.16 214.4 1.83
AR 0015 80F 2838.0 N/A 392.9 2445.1 N/A 13.84 86.16 214.4 1.83
AR 0015
AR 0015 *** DEVICE SUMMARY REPORT
AR 0015 CAPACITY <-----TOTAL-----> <------TOTALS %------> COMP.
AR 0015 DEFINED 5676.032 MB 100.00 RATIO
AR 0015 STORED 785.816 MB 13.84
AR 0015 PHYS.USED 428.908 MB 7.56 1.83
AR 0015 UNUSED 4890.216 MB 86.16
AR 0015
AR 0015 *** SUBSYSTEM SUMMARY REPORT ***
AR 0015 SYSTEM DEFINED-CAPACITY DISK-ARRAY-CAP FREE-DISK-ARRAY-CAP
AR 0015 PROD 726532.208 MB 117880.209 MB 57750.030 MB
AR 0015
AR 0015 NET-CAPACITY-LOAD(%) COLL.-FREE-SPACE(%) UNCOLL-FREE-SPACE(%)
AR 0015 TEST PROD OVERALL TEST PROD OVERALL TEST PROD OVERALL
AR 0015 0.00 51.01 51.01 0.00 47.55 47.55 0.00 1.44 1.44
AR 0015 1I40I READY
Figure 35. Entire Subsystem IXFP REPORT
Submitting the batch job shown in Figure 36 would achieve the same results.
// JOB WCWTEST1
// LOG
// EXEC DTRIATTN,PARM=′ IXFP REPORT′
/&
Figure 36. JCL to Produce an Entire Subsystem IXFP REPORT
B.4 IXFP/SnapShot Setup Job Streams
For the verification of IXFP/SnapShot for VSE/ESA, two RVA disks were made
available. In this section we present the job streams used to allocate and create
the test data. We used the following job stream to release the space on the RVA
and write the VTOCs to the disks:
// JOB INITDISK
DVCDN X′80E′
// EXEC DTRIATTN,PARM=′ IXFP DDSR,80E′
DVCDN X′80F′
// EXEC DTRIATTN,PARM=′ IXFP DDSR,80F′
// LOG
* WAIT UNTIL IXFP/SNAPSHOT HAS RELEASED THE SPACE BEFORE CONTINUING
// EXEC IESWAIT
DVCUP X′80E′
DVCUP X′80F′
// ASSGN SYS004,80E,SHR
// EXEC ICKDSF,SIZE=AUTO
54 RAMAC Virtual Array, Peer-to Peer Remote VSE/ESA