Icom HF/VHF/UHF ALL MODE TRANSCEIVER TV Receiver User Manual


 
66
13
SPECIFICATIONS
GENERAL
•Frequency coverage : Receive
30 kHz–199.999999 MHz*
400–470.000 MHz*
Transmit
1.800– 1.99999 MHz*
3.500– 3.9999 MHz*
7.000– 7.300 MHz*
10.100– 10.150 MHz
14.000– 14.350 MHz
18.068– 18.168 MHz
21.000– 21.450 MHz
24.890– 24.990 MHz
28.000– 29.700 MHz
50.000– 54.000 MHz*
144.000– 148.000 MHz*
430.000– 450.000 MHz*
*Depending on version.
•Mode : SSB, CW, AM, FM, WFM, RTTY
(WFM is for receive only)
•Number of memory : 107 (split memory: 99; scan edges: 6;
channels call channels: 2)
•Antenna connector : SO-239×2 (for HF/50 MHz and
144/430 MHz)/50
•Usable temperature : –10°C to +60°C (+14°F to +140°F)
range
•Frequency stability : Less than ±7 ppm from 1 min. to
60 min. after power ON. After that,
rate of stability change is less than
±1 ppm/hr. at +25°C (+77°F).
Temperature fluctuations (0°C to
+50°C; +32°F to +122°F) less than
±5 ppm.
•Power supply : 13.8 V DC ±15% (negative ground)
requirement
•Current drain : Transmit 20 A
(at 13.8 V DC) Receive squelched 1.8 A
max. audio 2.0 A
•Dimensions : 167(W)
×58(H)×200(D) mm
6
9
16(W)×2
5
16(H)×7
7
8(D) in
(projections not included)
•Weight : 2.45 kg (5 lb 6 oz)
•CI-V connector : 2-conductor 3.5 (d) mm (
1
8˝)/8
•ACC connector : 13-pin
TRANSMITTER
•Output power :
SSB, CW, FM, RTTY 5–100 W
(1.8–50 MHz bands)
5–50 W (144 MHz band)
2–20 W (430 MHz band)
AM 2–40 W (1.8–50 MHz bands)
2–20 W (144 MHz band)
2–8 W (430 MHz band)
•Modulation system :
SSB Balanced modulation
AM Low level modulation
FM Variable reactance modulation
•Spurious emissions : Less than –60 dB*
*spurious freq. : below 30 MHz: –50 dB (typ.);
above 50 MHz: –60 dB (typ.).
•Carrier suppression : More than 40 dB
•Unwanted sideband : More than 50 dB
•Microphone : 8-pin modular jack (600 )
connector
•KEY connector : 3-conductor 6.35 (d) mm (
1
4")
•RTTY connector : 3-conductor 3.5 (d) mm (
1
8")
RECEIVER
•Receive system :
SSB, CW, AM, RTTY Double-conversion superheterodyne
WFM
FM Triple-conversion superheterodyne
•Intermediate frequencies:
•Sensitivity
(pre-amp ON):
•Squelch sensitivity
(threshold; preamp ON) :
SSB Less than 5.6 µV
FM Less than 0.3 µV
•Selectivity* :
SSB, CW, RTTY More than 3.0 kHz/–6 dB
Less than 4.8 kHz/–60 dB
AM/FM-N More than 8.0 kHz/–6 dB
Less than 30.0 kHz/–40 dB
FM More than 12.0 kHz/–6 dB
Less than 30.0 kHz/–60 dB
*Without optional filter and with
mid band selected.
•Spurious and image rejection ratio:
HF More than 70 dB
50 MHz More than 65 dB
(except IF through)
144/430 MHz More than 65 dB
•Audio output power : More than 2.0 W
at 10% distortion
with an 8 load
•RIT variable range : ±9.99 kHz max.
•PHONES connector : 3-conductor 3.5 (d) mm (
1
8˝)/8
•EXT SP connector : 2-conductor 3.5 (d) mm (
1
8˝)/8
MODE 1st 2nd 3rd
SSB 69.0115 MHz 9.0115 MHz
AM 69.0100 MHz 9.0100 MHz
AM-N 69.0115 MHz 9.0115 MHz
RTTY 69.0105 MHz 9.0105 MHz
FM 69.0115 MHz 9.0115 MHz 455 kHz
FM-N 69.0100 MHz 9.0100 MHz 455 kHz
WFM 70.7000 MHz 10.7000 MHz
CW 69.0106 MHz 9.0106 MHz
Frequency
range
SSB/CW
10 dB S/N
AM
10 dB S/N
FM
12 dB SINAD
WFM
12 dB SINAD
0.5–1.8 MHz 13 µV
1.8–28 MHz
0.15 µV 2.0 µV
28–29.7 MHz 0.5 µV
50 MHz band 0.12 µV 1.0 µV 0.25 µV
76–108 MHz 10.0 µV
144/430 MHz
bands
0.11 µV 1.0 µV 0.18 µV