Filter
Top Products
9. Remove the four #4-40
socket head screws
positioning blades.
10. Pull elements guiding
lead wire through
holes.
11. Reverse the process by feeding the new blade wires through the holes and
silicone tubes.
12. Replace the four #4-40 socket head screws for positioning blades.
13. Connect the two short leads inside silicone tube.
14. Pass the two long leads through the long silicone tube and plug into its elec-
trical connection. NOTE: alignment of connector pin.
15. Check blade assembly to make sure it has free blade movement.
16. Close lid making sure all wires and air hoses do not interfere.
17. Connect air and power.
SILICONE TUBE NOT
SHOWN FOR CLARITY.
Front View Rear View
Connector
and socket
orientation
Pass tube
over lever
Place tube
over lever
4
5
3
1
2
STP Service continued
Blade Replacement
Blade Set K-7763
Replacement Blade set consists of:
1. Long lead top element
2. Short lead bottom element
3. Long silicone tube
4. Short silicone tube
5. Connector
3 - Long silicone tube
4 - Short silicone tube
5 - Connector
1 - Long lead-top element
2 - Short lead-bottom element
16