Filter
Top Products
Using the LitePro
LitePro 560/570 User’s Guide 29
Test Pattern
If the test pattern is turned on, it displays when the LitePro is first
powered on and also when no computers or video players are
connected to the LitePro. If the test pattern is turned off, it displays
only when the LitePro is first powered on. As long as the test pattern
is turned off, the only way to display it is to unplug the power supply
cord, then plug it back in again. (Refer to “select/enter” on page 21
for additional information about the test pattern.)
To enable or disable the test pattern:
1.
Press the
menu
button to display Menu 1.
2.
Use the right or left arrow buttons to highlight “Menu 2”.
3.
Press
select/enter
to display Menu 2.
4.
Use the right or left arrow buttons to highlight “Test Pattern”.
5.
Press
select/enter
to enable or disable the test pattern off.
RS-232
When the LitePro’s RS-232 connection is enabled, you can use the
LitePro’s remote control to send commands to your computer. To use
this feature, you must install the Remote Control Programmer that
was shipped with your LitePro. Refer to the
Remote Control
Programmer User’s Guide
for more information.
To enable or disable the RS-232 serial port:
1.
Press the
menu
button to display Menu 1.
2.
Use the right or left arrow buttons to highlight Menu 2.
3.
Press
select/enter
to display Menu 2.
4.
Use the right or left arrow buttons to highlight “RS-232”.
5.
Press
select/enter
to enable or disable the RS-232 port.
Auto Standby
When you enable Auto Standby, the LitePro automatically turns off
the projection lamp after a specified period of time. You can specify 5,
10 or 30 minutes. If Auto Standby is turned off, you can still turn off
the lamp by pressing the
standby
button on the remote. Refer to
page 17 and page 23 for additional information about Standby.
USING.FRA Page 29 Tuesday, January 28, 1997 9:55 AM