Filter
Top Products
Using the LitePro
30 LitePro 560/570 User’s Guide
To enable Auto Standby:
1.
Press the
menu
button to display Menu 1.
2.
Use the right or left arrow buttons to highlight “Menu 2”.
3.
Press
select/enter
to display Menu 2.
4.
Use the right or left arrow buttons to highlight “Auto Standby”.
5.
Press
select/enter
to cycle through the settings.
Reset
The Reset function changes all the menu function settings back to the
factory default states.
The defaults are:
To reset your adjustments:
1.
Press the
menu
button to display Menu 1.
2.
Use the right or left arrow buttons to highlight “Menu 2”.
3.
Press
select/enter
to display Menu 2.
4.
Use the right or left arrow buttons to highlight “Reset”.
5.
Press
select/enter
. The LitePro immediately resets all the function
settings.
• Rear Projection off • Test Pattern on
• Source Prompt on • RS-232 on
• Auto Standby 30 minutes • Reset off
• Source Enable all sources enabled • Text Mode off
• Prog Button clear white • Comp(ress) off
• Palette 24,389 • Sharpness off
• Language English • Loudness off
•Video Type NTSC •Mute off
USING.FRA Page 30 Tuesday, January 28, 1997 9:55 AM