Filter
Top Products
11
www.insigniaproducts.com
Connecting the power
To connect the power:
• Connect the power cord to the power jack on
the back of your TV, then connect the other
end to a surge protector or power outlet. If
you are using a surge protector, make sure
that it is turned on.
Installing the ferrite core
The ferrite core shields cables from interference.
You can use the core with any cables.
To install the ferrite core:
• Open the ferrite core, clip the core around a cable
near the plug, then close the core.
Connecting a cable or satellite box
Many cable or satellite TV boxes have more than
one connection type. To get the best video, you
should use the best connection type available. For
more information, see “What connection should I
use?” on page 10.
Using HDMI (best)
To connect a cable or satellite box using HDMI:
1 Turn off your TV and all connected equipment.
2 Connect the cable from the cable wall jack to
the cable-in jack on the cable box.
3 Connect an HDMI cable (not included) between
the HDMI IN 1(DVI) or HDMI IN 2 jack on the
back of your TV and the HDMI jack on the cable
or satellite box.
4 Turn on your TV, then turn on the cable or
satellite box.
5 Go through the setup wizard on page 20.
Cautions
• Make sure that you use the correct type of
power. See the label on your TV.
• If you do not intend to use your TV for an
extended period of time, turn off the surge
protector (if you are using one) or unplug the
power cord from the power outlet.
50 mm
Note
An HDMI cable carries both audio and video. You do
not need to use any audio cables.
Back of TV
HDMI cable
Cable or satellite box