Filter
Top Products
HMP Release 1.5 for Linux Software Installation Guide — August 2005 11
Installing the Software
========================================================================
Intel ® NetStructure ™ Host Media Processing Software 1.5
Redistributable Runtime
INSTALLATION
You will now have an opportunity to install software packages.
After the menu is displayed, enter the package number(s) of the desired
packages, separated by a space. Enter A for all packages, Q to quit.
Package dependencies will be automatically resolved during installation. For example,
selecting a single package will automatically install all packages required for that
selection.
Press ENTER to display the menu packages.
5. Press Enter.
The following menu is displayed:
Item Package Description
---- -------------------------------------------------------------------
1 Intel(R) NetStructure(TM) Host Media Processing Software (75 MB)
2 SNMP Component Manager (43 MB)
3 Documentation (16 MB)
A Install All (98 MB)
Q Quit Installation
Enter the packages you wish installed, separated by a space, or [A,a,Q,q]:
6. Enter the numbers or letter that correspond to what you want to install. Unless space or other
considerations dictate that you limit what you install, you can just enter a to install everything.
You will see messages about package installation order, checking for previously installed
packages, checking for sufficient disk space, and installation progress. Then the installation
menu (shown above) will reappear.
7. Enter q to quit and complete the installation process. The following message is displayed:
Do you wish to run config.sh to configure your system [Yn] ?
8. At this point, you have two options:
• Enter y if you already have obtained a license
1
or want to use the verification license
supplied with the software. Follow the procedure in Section 2.4, “Configuring the System
(Activating a License)”, on page 11.
• Enter n if you do not want to use the verification license or have not obtained the license
you want. After you have obtained a license, run
config.sh (located in
/usr/dialogic/bin) and follow the procedure in Section 2.4, “Configuring the System
(Activating a License)”, on page 11.
Note: You must run
config.sh at least once after installing the software
2.4 Configuring the System (Activating a License)
Configuring the system consists of activating an HMP Software license. You can activate the
verification license supplied with the software or another license you have obtained.
1.For more information about HMP Software licenses, see Section 1.2, “HMP Licenses”, on
page 7 and the Intel NetStructure Host Media Processing Release 1.5 for Linux License Man-
ager Administration Guide.