Filter
Top Products
HMP Release 1.5 for Linux Software Installation Guide — August 2005 15
Installing the Software
2.5 Running the Verification Demo
If you would like to verify that you have set up the HMP Software properly, you can run the
verification demo. This demo simply makes an IP call using SIP to let you know that the
installation and configuration were successful.
Note: This step is optional, but recommended.
To run the verification demo, perform the following:
1. Run
dlstart.
2. Change into the directory containing the verification demo or set it as the working directory:
/usr/dialogic/demos/Verification/VerificationDemo/Release.
3. Run the demo using the files in /usr/dialogic/demos/Verification/VerificationDemo/Release.
When you run the demo, you will see output like the following:
Welcome to the HMP Demonstration Program
The purpose of this demo is to establish a basic level
of functionality after installing and configuring the
Intel(R) NetStructure(TM) Host Media Processing Software.
This application will perform some sanity checking and
then wait for a Voice Over Internet Protocol (VOIP) call
to be placed into the system using a SIP or H.323 VOIP
phone configured to use the G.711 codec. After connecting
a message prompt will be played out to the calling party.
Press ENTER to continue.....
Checking that the HMP service is running.......
Getting the host IP address for eth0.....
Opening Prompt File........
Opening Voice Device.......
Opening Global Call IP Device.......
Starting the Global Call subsystem.....
The system is initialized and ready for a call.
Place a SIP or H.323 call to the IP address of eth0
If you need to restart HMP services, you will need to be root and use the following command
sequence:
dlstop;dlstart
An example of output from the dlstart command follows.
Note: This output will vary depending on the license you have enabled.
% dlstart
STARTING INTEL DIALOGIC SERVICES
Starting CORBA Event Server: [ OK ]
Starting CORBA Name Server [ OK ]
Starting Error Logger: [ OK ]
Starting Device Mapper: [ OK ]
Starting Timeslot Doler: [ OK ]
Starting Intel(R) NetStructure(TM) DM-family board(s).
CHEETAHSTART: Removing temp files.