Filter
Top Products
- 16 -
Manual Search:
This is for searching for digital channels on a single
broadcast frequency. The frequency channel number (21-
68) is entered in the box at the top left of the screen and
the received signal level and signal quality can be ob-
served on the two bar graphs at the bottom. When OK
is pressed, the TV searches that frequency and display
a list of the channels found.
Hint
The bar graphs of signal quality and signal level
give a good indication of whether any channels are
likely to be found. If only the signal level graph
shows a high value then it is likely that an analogue
channel occupies that broadcast frequency. If the
signal quality bar is high as well then it is a digital
frequency and digital channels will probably be
found.
Again, channels which duplicate those already in the
channel list are ignored. However, the manual channel
search will find all channels on the broadcast frequency.
When either search is finished, press the MENU button
to return to normal broadcast viewing, to watch the new
digital terrestrial television channels found.
Factory Settings:
To reset the TV, highlight the Factory Settings line in
the menu and press OK. A warning screen is displayed
in case of accidental operation.
Highlight the YES button with the or button and
press OK to erase all the channels and settings. A
message will be displayed on the screen.
Press the OK button to start the automatic search.
When the automatic search has finished, the EDIT
PR LIST menu appears.
Common Interface
It is required to subscribe to a pay channel company to
view the pay channels of the Digital Terrestrial broad-
casting.
Obtain the Conditional Access Module (CAM) and the
Viewing card by subscribing to a pay channel company,
then insert those to the Television using the following
procedure.
1. Switch off the TV and unplug from the mains.
2. Insert the CAM, then Viewing Card to the slot
that is located in the terminal cover at the left-hand
side of the TV (from front view).
The CAM should be correctly inserted, it is impos-
sible to insert fully if reversed. The CAM or the TV ter-
minal may be damaged if the CAM is forcefully inserted.
3. Connect the TV to the mains supply, switch on
and then wait for few moments until the card is
activated.
Some CAMs may require the following set up. Please
set the CAM by entering the DTV menu, Common Inter-
face then pressing OK button. (CAM set up menu is not
displayed when it is not required.)
To see the viewing contract information, press MENU,
Select DTV and Press OK, then Select Common Inter-
face and press OK.
When no module is inserted, No CI Module appears.
Refer to the module instruction manual for details of
the settings.
Setting the TV
Menu System
Your TVs analogue part has been designed with a menu
system, to provide an easy manipulation of a multi-func-
tion system. The TV is controlled by choosing the com-
mands, which are displayed on the screen.
MAIN MENU
Press the MENU button. The MENU will be displayed
in the middle on the screen.
To select a sub-menu use or button, and press
or button or directly press OK button.
Use the MENU button to go back to the previous
programme when the menu does not appear on the
screen.
JVC-AK49-IDTV-ENG-28&3229W-STEREO-BSI-C1815S-(AV-28&32E50SK)-50066123.p65 24.05.2005, 15:1616