Filter
Top Products
Connecting to a Digital TV Receiver w/HDCP
By inputting a high bandwidth Digitai Content Protection High Definition picture source to the
Digitaiqn terminal of this television, high-definition pictures can be displayed on the screen in
their digitai form. (This terminat is for use in the future when high bandwidth Digital Content
Protection DTV decoders and DVD players and D_VHS are put on the market.)
[
AUDIO G
After the connections
have been made,
tighten the screw to
secure the cables°
DIGITAL OUT
DTV decoder
1 Connect the DTV digital RGB output terminal to the digital input terminal of the television,
and then tighten the 2 screws.
2) Connect the DTV decoder left audio output to the DIGITAL-IN left audio input.
3) Connect the DTV decoder right audio output to the DIGITALqN right audio input.
• The Digitalqn terminal can only be used with 1080i, 720p and 480p picture signals. Set the
DTV decode DigitaFOut terminal output setting to 1080i, 720p or 480p. For detailed
information, refer to the DTV decoder instruction manual. If you can not display the picture
because your DTV decoder does not have a DigitaFOut terminal output setting, use the
component Video Input (or the S-Video Input or Video Input). (Refer to page 15) In this case
the picture wilt be displayed as an analog signal.
• The Digitatqn terminal is not compatible with the picture signal of a personal computer.
• Use a DVI-D Single Link 19-pin cable (commercially available) in order to digitally connect
the television with a DTV decoder.
If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may
be stightly shifted. In cases such as this, the horizontal baiance can be adjusted by accessing
"DIGITAL-IN" in the iNITiAL SETUP Menu. (Refer to page 41 .)
16