Filter
Top Products
20 EN
6
Access DBS Receiver Brand Set screen
Press OK.
7
Enter DBS Receiver’s brand
Press the appropriate
Number keys to enter
the brand code from the
following list, then
press OK.
The program currently
received through the
DBS receiver appears
for about 10 seconds.
● If the DBS receiver’s channel changes to the
channel listed below for your brand, setting is
complete
JVC = 100
ECHOSTAR = 100
PRIMESTAR = 55
SONY = 205
RCA = 205
Press OK and “DBS
RECEIVER CONTROL
IS ON” appears on the
screen for about 5
seconds, then it
returns to the normal
screen.
● If the DBS receiver’s
channel does not change as shown above
1 Press
@
#
to move the highlight bar to “NO”.
2 Press OK.
3 Re-enter the correct code.
BRAND CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
PRIMESTAR 50
SONY (DSS) 41
RCA (DSS) 40
DBS RECEIVER BRAND SET
4 0
PRESS NUMBER KEY (0–9)
THEN (OK) TO TEST
PRESS (MENU) TO END
INITIAL SETTINGS (cont.)
DBS RECEIVER BRAND SET
51
DID YOUR DBS RECEIVER
CHANGE TO CHANNEL 100?
2
YES
3
NO
PRESS (
2
3
), THEN (OK)
PRESS (MENU) TO END
OK
@
#
123
456
7
89
0
VCR TV CABLE/DBS
6 7
7
NOTES:
●
The Controller may not work with all types of DBS receiver.
●
If your DBS receiver does not respond to the code, you
cannot use the Controller to change satellite channels. In this
case, make sure to leave the DBS receiver turned on and
tuned to the proper channel before the scheduled start time of
timer recording. In addition, if your DBS receiver is equipped
with a timer, you can also use “Satellite Auto Recording”
(
੬
pg. 54).
●
The VCR can only change the satellite channel through the
Controller during timer recording.
●
If your DBS receiver cannot be operated with a remote
control (because it has no remote sensor), you cannot use the
Controller to change its channels. Make sure to leave the DBS
receiver turned on and tuned to the proper channel before the
scheduled start time of timer recording.
●
For customers in U.S.A.: If you are unable to set the
Controller, contact JVC toll free at 1-800-252-5722.
VDA300U-EN02-20 03.7.18, 12:10 PM20