Filter
Top Products
EN 55
JLIP ID Number
Setting
The JLIP (Joint Level Interface Protocol) terminal is used
to connect the VCR to a personal computer or similar
device. By connecting through the JLIP terminals, you
can control the VCR during editing and certain other
operations, from the connected personal computer or
similar device.
When connecting this VCR to another device using the
JLIP terminals, each device must have a different JLIP ID
number.
The JLIP ID number of this VCR is preset to “1” when
shipped from the factory. You can change this number to
any other number between 1 to 99.
To change the JLIP ID number of this VCR, follow the
procedure below.
1
Access Main Menu screen
Press MENU.
2
Access Initial Set Up screen
Press %fi to move the highlight bar (arrow) to
“INITIAL SET UP”, then press OK.
3
Select JLIP ID Set Up screen
Press %fi to move the
highlight bar (arrow) to
“JLIP ID SET UP”, then
press OK.
4
Set JLIP ID Number
Press the Number keys
to enter the desired ID
number, then press OK.
5
Return to normal screen
Press MENU.
JLIP ID SET UP
1
PRESS NUMBER KEY (O-9)
OR (
2
3
), THEN (OK)
PRESS (MENU) TO END
INITIAL SET UP
CLOCK SET UP
3
JLIP ID SET UP
PRESS (5∞), THEN (OK)
PRESS (MENU) TO END
NOTE:
For further details on the JLIP system or devices, consult your
nearest JVC dealer.
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
123
456
7
89
0
VCR TV CABLE/DBS
1 5
2 3
2
–
4
4
VDA300U-EN48-55 03.7.18, 12:13 PM55