JVC DR-DX5SEK DVR User Manual


 
Filename [DX5SEK_06DVD Operation.fm]
Masterpage:Left+
34 EN
BASIC OPERATIONS ON DVD DECK
Page 34Thursday, 10 November 2005 16:34
1 Load a recordable disc.
For details, refer to APlacing A DiscB (A pg. 9).
2 Press DV/HDD/DVD SELECT on the unit repeatedly or DVD on
the remote control so that the DVD lamp lights up on the unit.
3 Press PR +/– or the number keys to select the channel you
wish to record.
4 Press REC MODE repeatedly to select the recording mode,
then press ENTER.
Each time you press REC MODE, the recording mode changes
as follows:
XP N SP N LP N EP N FR (60-360*, 420, 480) N (Back to
the beginning)
* The value is selectable from 1 to 6 hours in 5-minute intervals by
pressing
DE repeatedly after selecting AFR60–FR360B. To change the
value in 30-minute intervals, press and hold
DE.
For details on the recording mode, see the right column.
5 Press R on the unit to start recording. Or while holding R , press
I on the remote control.
The DVD recording lamp lights up on the unit.
6 Press R and W on the remote control simultaneously to pause
recording.
To resume recording, press R and I simultaneously.
7 Press o twice to stop recording.
It takes about 10 seconds to end the writing session when you
stop recording.
NOTES:
When switching from the HDD to the DVD deck, or when the unit
is turned on while a playback only disc is loaded, the DVD deck
enters into resume stop mode automatically and the TV screen
becomes all blue. To display the EE* signal on the screen, press
o.
* EE means Electronics to Electronics, no mechanical movement is
involved. EE signal means a programme received with the unit's tuner or
the AV input signals.
It is recommended to format a DVD-RAM disc before use if you
use the disc on this unit for the first time.
When using a brand-new DVD-RW disc, format the disc either in
VR mode or in Video mode. (A pg. 78)
Recordings made on DVD-R/RW disc must be finalised to play
back on other DVD players. Perform AFinalise A Disc (DVD Deck
Only)B (A pg. 79).
You can record up to 99 programmes and 99 play lists on each
disc.
Some programmes can only be recorded one time.
When recording is started, an index of the first part of recording is
automatically recorded. (A pg. 51) To record satellite
programmes, refer to page 50. To delete the index, refer to
page 53.
Recording sometimes may stop or cannot be performed even
when there is enough available capacity remaining on the disc if
the signal source is copy-protected or intermittent.
It is not possible to record on both DVD and HDD simultaneously.
It is not possible to record from this unit’s built-in tuner to the DV
deck.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the AbpsB unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programmes where quick movement occurs,
such as sports programmes, and LP or EP for talk shows, etc. with
relatively less movement.
The recording modes for a 4.7 GB disc are set as follows:
For details on FR mode, refer to AFree Rate FunctionB
(A pg. 36).
Basic Recording
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
ATTENTION:
It is not possible to record programmes on a DVD-R disc which
has already been finalised.
R
DV/HDD/DVD
SELECT
REC
MODE
WI
o
PR +/
-
I
R
0-9
REC MODE
DVD
PR+/
-
W
o
CABLE/SAT
DVDTV
ENTER
DVD lamp
DVD recording
lamp
Recording mode Recording amount
(approx.)
Maximum recording
time (approx.)
XP 10 Mbps 1 hour
SP 5 Mbps 2 hours
LP 2.5 Mbps 4 hours
EP 1.6 Mbps 6 hours
FR
60-360
(A pg. 36)
The amount varies
depending on the
selected time.
1 – 6 hours
420 7 hours
480 8 hours
DX5SEK_00.book Page 34 Thursday, November 10, 2005 4:35 PM