Filter
Top Products
EN 41
12
45
3
6
8
0
7
9
CHECK INPUT DATA
4
Press OK and the Program
screen appears.
The G-CODE number you
entered and the matching
Timer-Recording informa-
tion is displayed on the
Program screen. Check to
make sure it’s accurate.
● To timer-record daily or
weekly serials, press DAILY (NUMBER “8”) or
WEEKLY (NUMBER “9”). “DAILY” or “WEEKLY”
appears on the Program screen. Pressing the button
again makes each corresponding display disappear.
● If you made a mistake, press CANCEL and, after
pressing MENU as many times as necessary to access
the G-CODE screen, input the correct G-CODE number.
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys (0-9),
PUSH JOG, CANCEL and MENU.
SET TAPE SPEED
5
Press SP/EP.
CHECK/CORRECT INPUT
DATA
6
If the data is correct as it is, go to step 7. If not, press
OK or PUSH JOG ™ £ until the item you want to
change begins to blink. Then press the appropriate
NUMBER keys, CH
5
∞
or PUSH JOG
5
∞
to obtain
the desired setting.
● If you are using a DBS receiver, the BAND indication
(TV or CATV or DBS) appears at right of the channel
number display when OK or PUSH JOG ™ £ is
pressed. See "ATTENTION FOR DBS RECEIVER
USERS" on page 43.
RETURN TO NORMAL
SCREEN
7
Press MENU as many times as necessary.
● Press just once to access the Auto Timer screen
(੬ pg. 45).
ENGAGE TIMER MODE
8
Press TIMER. The VCR turns off automatically.
NOTES:
●
To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
●
In case of a power failure after programming, the VCR’s
memory backup keeps your selections for approximately
10 minutes.
●
When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.
PROGRAM 1
(G-CODE 12345678)
DATE 12/24 WED
START 12:00 PM
STOP 1:00 PM
CHANNEL 40 SP
PRESS (8=DAILY, 9=WEEKLY
SP/EP=REC SPEED)
PRESS (MENU) TO END
TIMER
NUMBER "9"
NUMBER
NUMBER "8"
CANCEL
CH
SP/EP
MENU
OK
PUSH JOG