JVC HR-S9400EE VCR User Manual


 
EN 21
Names of
special-effects
playback
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
-7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
Audio is output.
Audio is not Audio is Audio is not
Audio is output.
output. output. output.
TimeScan
Speed LP
Speed SP
Audio output
* Still mode cannot be engaged using the remote control's PUSH JOG button. When the still mode is
engaged by pressing PAUSE, the TIME SCAN indicator does not light even though you can hear TimeScan
audio ( pg. 15) .
The VCR's TimeScan indicator lights during TimeScan.
The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
To resume normal playback, press PLAY.
When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change depending on how far it is turned.
Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
Depending on the type of TV being used, the upper part of the picture may be distorted or there may be a loss of colour
during still, frame-by-frame playback, 2x search of LP recordings, or depending on the tape being used.
Picture may appear distorted in comparison to normal playback.
In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
5
%
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (See below).
TimeScan Audio
The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.
The default setting is "ON".
1 Press MENU twice to access the Main Menu screen.
2 Move the highlight bar (pointer) to "MODE SET" by pressing PUSH JOG %
, then press OK.
3 Move the highlight bar (pointer) to "TIME SCAN AUDIO" by pressing PUSH JOG %
, then
press PUSH JOG to select "ON" or "OFF".
4 Press MENU to return to the normal screen.
MODE SET
AUTO TIMER : OFF
O. S. D. :ON
S-VHS : AUTO
EDIT :OFF
TIME SCAN : ON
AUDIO
[5
] = [ ] : ON/OFF
[MENU] : EXIT