Filter
Top Products
22
CABLE
BOX
DSS receiver
Controller
(suggested locations)
DSS receiver
Controller
Transmitter
Connected to
ANT. IN
Connected
to VIDEO/
AUDIO IN
Your VCR
Your VCR
The following procedure is required if you receive satellite
channels through a DSS (Digital Satellite System) receiver and
you want your VCR to change to receiver's channels during
timer recording.
The VCR can control the DSS Receiver during timer recording
using its Controller.
NOTE:
The Controller can automatically change the DSS Receiver
channels when the VCR has been programmed using On-
Screen Timer Programming (੬ pg. 46).
Because satellite programming does not use PlusCode; the
Controller can not change the DSS Receiver channels during
VCR Plus+ Timer Recording.
Situate And Connect
Controller
INITIAL SETTINGS (cont.)
DSS Receiver
Control
SITUATE CONTROLLER
1
Place the Controller so that the path between its
transmitter and the DSS receiver's remote sensor is
unobstructed.
ATTACH CONTROLLER
2
Fasten securely using the supplied adhesive strips.
CONNECT DSS RECEIVER
TO VCR
3
The connection method depends on the type of DSS
receiver you have.
If your DSS receiver has AUDIO and VIDEO OUT
connectors . . .
. . . connect them to the AUDIO and VIDEO IN
connectors on your VCR.
If your DSS receiver doesn’t have AUDIO and VIDEO
OUT connectors . . .
. . . connect the antenna output connector on the DSS
receiver to the ANT.IN connector on the rear of your VCR.
NOTE:
Refer to your DSS receiver's instruction manual during
connection.
CONNECT CONTROLLER
TO VCR
4
Connect to the CABLE BOX connector on your VCR.
Suggested Location
Place the DSS (Digital Satellite System) receiver on top of the
VCR. Attach the VCR's Controller to the top of the VCR with the
Controller’s transmitter pointed towards the DSS receiver's
remote sensor.
Attention:
The Controller can also control a cable box. If both a DSS
receiver and a cable box are used, position the controller so its
signal reaches the remote control sensors of both the DSS
receiver and cable box.