Filter
Top Products
Filename [XVC2829US_09Editing.fm]
Masterpage:Left0
56 EN
Page 56 8 December 2004 9:56 am
REMOTE
Remote Control
Functions
Remote A/B/C/D Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the Remote
Keep pressing VCR down during steps A – B.
A
Change the remote control code.
Press the number key “1” for A, “2” for B, “3” for C or
“4” for D.
B
Set the remote control code.
Press ENTER to set the code.
NOTE:
Once the batteries are removed, the remote control code is back
to A.
On the unit
A
Turn off the unit.
Press POWER on the unit.
B
Display the code.
Press 4 PLAY on the unit for over 5 seconds while the
unit is turned off. The code currently set appears on the
front display panel.
● If the code displayed on the front display panel is different
from the code set on the Remote, go to step C.
C
Change the unit’s code.
Press 8 STOP on the Remote. The code currently set on
the Remote will be applied to the unit.
NOTE:
Even if you unplug the end of the mains power cord from the
mains, the code currently set remains.
Before performing the following steps:
Slide the TV/VCR/DVD switch on the Remote to the right.
VCR
7
STOP
ENTER
Number keys
Slide to the
right.
POWER
3
PLAY
XVC2829US_01.book Page 56 Wednesday, December 8, 2004 10:48 AM