Filter
Top Products
Masterpage:Right-No-Heading
EN 69
Filename [XVC2829US_11Trouble.fm]
Page 69 8 December 2004 10:48 am
OTHER PROBLEMS
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. The image of TV broadcast appears
distorted on the TV screen.
● The unit leaves turned on and the DVD
deck is selected.
Turn off the unit, or press VCR to select
the VCR deck, then press TV/VCR so that
the VHS indicator disappears from the
front display panel.
2. Whistling or howling is heard from the
TV during camcorder recording.
● The camcorder’s microphone is too
close to the TV.
Position the camcorder so its microphone
is away from the TV.
● The TV’s volume is too high. Turn the TV’s volume down.
3. When scanning channels, some of
them are skipped over.
● Those channels have been designated to
be skipped.
If you need the skipped channels, restore
them. (
੬ pg. 25)
4. The channel cannot be changed. ● Recording is in progress. Press 9 PAUSE to pause the recording,
change channels, then press 4 PLAY to
resume recording.
5. Channel settings that were made
manually seem to have changed or
disappeared.
● After the manual settings were made,
Auto Channel Set was performed.
Perform manual setting again.
6. Even though Auto or Semiauto Clock
Set has been performed, the clock is
incorrect.
● The clock setting data received from the
host channel is incorrect.
Select a different host channel during
“Semiauto Clock Set” (
੬ pg. 23), or
perform “Manual Clock Set” (
੬ pg. 23).
ATTENTION
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the AC power cord. Then plug it in again and turn the unit on. Take out the cassette. After checking the cassette,
operate the unit as usual.
Tray Lock
You can lock the disc tray to prohibit the unwanted disc ejection by children.
To lock the disc tray.
While the unit is turned off, press and hold 8 STOP, then press
x OPEN/CLOSE on the unit. “LOCK” appears on the front display
panel and the disc tray is locked.
To unlock tray
While the unit is turned off, press and hold 8 STOP, then press x OPEN/CLOSE on the unit. “UNLOCK” appears on the display
panel.
XVC2829US_01.book Page 69 Wednesday, December 8, 2004 10:48 AM