JVC HR-XVS20E DVD Player User Manual


 
Filename [XVS20EX_10Subsidiary.fm]
Masterpage:Left+
76
EN
Page 76 February 10, 2003 1:07 pm
SUBSIDIARY SETTINGS (cont.)
Audio Settings
* The default setting is
bold
in the table below.
8
DIGITAL AUDIO OUTPUT
PCM ONLY
DOLBY DIGITAL/PCM
STREAM/PCM
Set to the appropriate mode according to the type of the device connected to
DIGITAL AUDIO OUT connector on the rear of unit.
It is not necessary to set this mode when you connect no device to DIGITAL
AUDIO OUTconnector.
PCM ONLY
:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the linear PCM digital input connector of other audio
device.
DOLBY DIGITAL/PCM
:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the digital input connector of a Dolby Digital decoder
or an amplifier with a built-in Dolby Digital decoder.
STREAM/PCM
:
Select this when you connect the unit’s DIGITAL AUDIO OUT
connector to the digital input connector of an amplifier with a built-
in DTS, Dolby Digital, or MPEG multichannel decoder.
8
DOWN MIX
Lt/Rt
Lo/Ro
Set to the appropriate mode according to your audio system when you play
back a DVD VIDEO disc recorded with surround multichannel audio. This
setting affects only the analogue audio output signal from the AUDIO OUT
connectors when playing back a DVD VIDEO disc recorded with surround
multichannel audio.
Lt/Rt
:
Select this when you enjoy multichannel surround audio by
connecting the unit’s DIGITAL AUDIO OUT connector to a
surround decoder or an internal amplifier.
Lo/Ro
: Select this when you enjoy conventional 2-channel stereo
audio by connecting the unit’s DIGITAL AUDIO OUT
connector to a stereo amplifier/receiver or TV, or when you
dub audio of a DVD VIDEO disc recorded with surround
audio to your MD, cassette, etc.
NOTE:
The “DOWN MIX” function does not work when the 3D Phonic function is activated.
(
pg. 43)
8
COMPRESSION
ON
OFF
When this function is set to “ON”, you can compress the dynamic range (the
difference between the loudest and quietest audio signals) of the sound.
This function is available with DVD VIDEO discs recorded with the Dolby
Digital format.
ON
: Audio is played back with the dynamic range compressed.
OFF:
Audio is played back as it was recorded.
NOTES:
It is recommended to set to “ON” when you enjoy surround sound at night.
The “COMPRESSION” function works only when playing back a disc recorded with
Dolby Digital format. The setting is not effective for other discs.
The “COMPRESSION” function does not work when the 3D phonic function is
activated. (
pg. 43)
XVS20EX_01.book Page 76 Monday, February 10, 2003 1:07 PM