Filter
Top Products
Filename [XVS20EX_10Subsidiary.fm]
Masterpage:Left+
86
EN
Page 86 February 10, 2003 1:07 pm
SUBSIDIARY SETTINGS (cont.)
Video Channel Set
Video channel (RF output channel) is the channel on which your TV receives picture and sound signals from the unit through the RF
cable.
If you have connected the unit to your TV via the AV connection (
੬
pg. 12), since you do not need the video channel
you have to set the video channel to off.
If you have connected the unit to your TV via the RF connection (
੬
pg. 12), you have to set the correct video
channel.
A
Access the Video Channel Set mode.
Hold down
8
on the unit until the front display panel
shows the following.
B
Set the RF output system.
The blinking number on the display indicates the RF
output system of your country.
●
If you have selected MAGYARORSZÁG,
C
ESKÁ REPUBLIKA,
POLSKA or OTHER EASTERN EUROPE for the country setting
(
੬
pg. 13, 18), press
rt
to set to “2”.
●
For other countries, set to “1”. Then press
OK
.
(1: B/G 2: D/K)
C
Set the video channel.
With AV Connection
Press
PR –
until the front display panel shows “1 – –” (or
“2 – –”).
●
Now the video channel is set to off.
With RF Connection
Press
PR +
or
–
to set the unit to a vacant channel
between 22 and 69 which is not occupied by any local
station in your area.
(Example) If channel 50 is available in your area
Then set your TV to UHF channel 50.
●
If the two vertical white bars appear
clearly on the TV screen as shown to
the right, go to step
D
.
●
If the two vertical white bars do not
appear clearly, re-set the unit to
another vacant channel and try again.
NOTES:
●
If you set the unit to a channel which is occupied by a local
station or has neighbouring channels that are occupied by
local stations, the picture reception quality will be affected
and some interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no broadcast on
neighbouring channels.
●
If you cannot obtain the two vertical white bars clearly with
any channel between 22 and 69, consult your JVC dealer.
D
Exit the Video Channel Set mode.
Press
OK
on the remote control.
IMPORTANT
Perform the following steps only if —
— Video Channel Set has not been done correctly by the Auto Set Up function (
੬
pg. 13),
— interference appears in the TV picture after you have moved to a different area or a new station has started broadcasting in your
area.
— you change the connection between your unit and TV from RF connection to AV connection, or vice versa.
Before performing the following steps:
Make sure the unit’s power is off and there is no cassette inserted in the unit.
With AV Connection
To view picture signals from the unit, set your TV to its
AV mode.
With RF Connection
The channel on which the TV screen in step
C
appears clearly is your video channel.
To view picture signals from the unit, set your TV to
the video channel.
XVS20EX_01.book Page 86 Monday, February 10, 2003 1:07 PM