Filter
Top Products
13
ENGLISH
External Speaker Connection
How to connect the cords
Note:
It is recommended to use the
speaker unit—TS-C500SPG
(not supplied) as the external
speakers. You can also
connect any speakers of the
following specifications:
• Impedance: Between 6 Ω
and 8 Ω
• Power handling capacity:
More than 3 W
ª·
ª·
When using external
speakers, set this to
EXTERNAL.
External speakers
(Ex. TS-C500SPG)
To speaker
input terminals
To speaker
input terminals
Ferrite core (supplied)
Attach the supplied ferrite cores to the speaker cords when using external speakers.
Attach the ferrite cores as near to the SPEAKER OUT L/R terminals on the rear panel
of the Monitor as possible.
Caution:
• Do not short-circuit the 9 and (
speaker cords each other. (Refer also to
the instructions supplied with the
speaker unit when connecting
speakers.)
How to attach the ferrite core
Connecting the External Cooling Fan Unit
When installing this Monitor vertically, it is
required to attach the external cooling fan
unit (not supplied).
Notes:
• When installing this Monitor vertically, it is
also required to set the speed of the internal
cooling fan to “HIGH” (see page 25).
• If you install the Monitor in such a way not
instructed in this manual (for example,
installing it diagonally), the cooling fan unit
may not be able to cool down the internal
heat enough to make the Monitor operate;
therefore, reinstallation or another method
for cooling will be required. Consult your
dealer in such a case.
• For more detailed connection, refer to the
manual supplied with the external cooling
fan unit.
AC INAUDIO
L
OUT
R
RGB A
AUDIO
IN
REMOTE
RS-232C
WIRED
MAKE
OPTION
Cooling Fan Unit:
TS-C01FANG
(not supplied)
Cooling Fan Unit:
TS-C01FANG
(not supplied)
04-13_GM_X50S.p65 04.3.1, 2:41 PM13