Filter
Top Products
6
Parts Identification (Continued)
Monitor: Rear Views 2
1 OPTION terminal (page 13)
Connect the power cord of the Cooling Fan Unit (not
supplied) when installing the Monitor vertically.
2 SPEAKER OUT L/R terminals (page 13)
Connect external speakers, such as unique JVC speakers
(not supplied), etc.
3 INTERNAL/EXTERNAL (built-in speaker/external
speaker) selecting switch (page 13)
INTERNAL: To use built-in speakers.
EXTERNAL: To use external speakers.
4 RGB A input terminals (page 12)
Input terminal (D-sub, 15 pin)
Connect to the video output terminal of a personal
computer.
Note:
• Use a cord as short as possible when connecting a
personal computer to this terminal. (Recommended
length is within 3 m.)
AUDIO IN terminal (stereo mini jack)
Connect to the audio output terminal of a personal
computer.
AC INAUDIO
L
OUT
R
RGB A
AUDIO
IN
REMOTE
RS-232C
WIRED
MAKE
POWER
EXTERNAL
R
SPEAKER OUT
L
INTERNAL
OPTION
4 5 6 7 8
2
3
1
5 REMOTE terminals (page 12)
RS-232C terminal (D-sub, 9 pin)
Connect to the RS-232C terminal of a personal computer.
For the control method using this terminal, consult an
authorized JVC dealer.
MAKE terminal (mini DIN, 4pin)
Connect an external control unit. (See page 12.)
WIRED terminal (stereo mini jack)
Connect a wired remote control unit to this terminal.
Note:
• When the above three terminals are used at the same
time, transmitted commands through the MAKE
terminal have priority over those through the other
terminals.
6 AUDIO OUT terminals (pin jack) (page 12)
Connect to the audio input terminals of external
equipment such as an amplifier.
7 AC IN terminal (page 12)
Connect the supplied power cord to this terminal.
8 POWER switch (page 14)
When this switch is set to “| (on),” you can turn on and
off (on standby) the Monitor by using the POWER button
on the remote control or the button on the Monitor.
04-13_GM_X50S.p65 04.3.1, 2:41 PM6