Filter
Top Products
18
Video Adjustments (Continued)
To make an adjustment while viewing the adjustment
bar
After step 3 on page 17, proceed as follows:
1 Press 5/∞ to move the cursor (3) to “sub menu.”
2 Press 3 to display the Sub Menu.
The Sub Menu for H SIZE appears on the screen.
3 Press 5/∞ to select the Sub Menu you want to adjust.
Each time you press the button, the Sub Menu changes as
follows:
4 Press 2/3 to adjust the selected item.
5 Repeat steps 3 and 4 to adjust the other items.
6 Press MENU/EXIT (or MENU on the Monitor) three times
to exit from the menu operations.
To reset the adjustments
After step 3 on page 17, proceed as follows:
1 Press 5/∞ to move the cursor (3) to “reset.”
2 Press 3.
The confirmation screen appears.
3 Press 3 again to reset the adjustments.
To cancel the reset, press MENU/EXIT (or MENU on the
Monitor).
Note:
• Adjustment values for both horizontal and vertical sizes of
the screen are so related that if one is adjusted up to near
the maximum value, the attainable value of the other will
be decreased.
:+01
H SIZE
+
++
+
Are you sure?
"YES"
then key.
"NO" then key.
MENU
reset
H SIZE H POSITION
V POSITIONCLOCK PHASE
V SIZE
DOT CLOCK
4
Press 5/∞ to move the cursor (3) to the
item you want to adjust.
Item Adjustment range
H (horizontal) SIZE*
1
–40 to +40
H POSITION*
1
Varies depending on other
settings
V (vertical) SIZE*
1
–40 to +40
V POSITION*
1
Varies depending on other
settings
DOT CLOCK*
2
–10 to +10
CLOCK PHASE*
2
–20 to +20
sub menu See “To make an adjustment
while viewing the adjustment
bar” on the right column.
reset See “To reset the adjustments” on
the right column.
*
1
Size and position adjustments are so related that if one
is adjusted much, the other’s adjustable range will be
reduced.
*
2
DOT CLOCK is the function to adjust the pixel
sampling number of the A/D converter to the
resolution (the vertical pixel number) of the input
signal.
CLOCK PHASE is the function to adjust the sampling
timing (phase) to the phase of the input signal.
You can use the two functions to reduce flickering and
blurring on the screen when using the RGB A or RGB
B input.
5
Press 2/3 to adjust the selected item.
Note:
•During size and position adjustments, the Monitor
screen may be distorted. This is normal, but not a
malfunction of the Monitor.
6
Press MENU/EXIT (or MENU on the
Monitor) twice to exit from the menu
operations.
14-21_GM_X50E.p65 04.3.14, 3:30 PM18