Filter
Top Products
25
ENGLISH
Cursor (3)
STATUS DISPLAY
CONTROL LOCK
REMOTE SWITCH
HD SIGNAL MODE
FAN SPEED
WHITE BALANCE
TIMER
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: OFF
: OFF
: MODE1
: 1080i
: LOW
Setting the Speed of the Internal Cooling Fan
Set the speed of the internal cooling fan to “HIGH” when
installing the Monitor vertically, so that the internal heat of
the Monitor is released more effectively.
Note:
• When installing this Monitor vertically, it is also required to
attach the external cooling fan unit. (See page 13.)
1
On the remote control:
Press VOLUME – while holding MENU/
EXIT to display the Setup Menu.
On the Monitor:
Press 2 while holding MENU to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“FAN SPEED.”
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select the desired setting.
Each time you press the button, the speed of the internal
cooling fan changes as follows:
LOW: Initial setting. Normally select this.
HIGH: Select this when installing the Monitor
vertically.
4
Press MENU/EXIT (or MENU on the
Monitor) once to exit from the menu
operations.
Adjusting the White Balance
G GAIN, B GAIN and R GAIN can be finely adjusted
separately for “HIGH” and “LOW” settings of the color
temperature.
1
On the remote control:
Press VOLUME – while holding MENU/
EXIT to display the Setup Menu.
On the Monitor:
Press 2 while holding MENU to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“WHITE BALANCE.”
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 3 to display the White Balance
Adjustment Menu.
4
Press 5/∞ to move the cursor (3) to the
item you want to adjust.
5
Press 2/3 to adjust the selected item.
6
Repeat steps 4 and 5 to adjust the other
items.
7
Press MENU/EXIT (or MENU on the
Monitor) twice to exit from the menu
operations.
Notes:
• Adjustable range will vary among the Monitors.
• “MAX” may appear soon after you begin adjustment. This
is normal but not a malfunction.
Cursor (3)
STATUS DISPLAY
CONTROL LOCK
REMOTE SWITCH
HD SIGNAL MODE
FAN SPEED
WHITE BALANCE
TIMER
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: OFF
: OFF
: MODE1
: 1080i
: LOW
R GAIN
G GAIN
B GAIN
sub menu
reset
ADJUST:
WHITE BALANCE:HIGH
SELECT:
EXIT:
MENU
: 000
: 001
: 002
+
–
(To be continued on the next page)
22-31_GM_X50S.p65 04.3.1, 2:42 PM25