Filter
Top Products
21
ENGLISH
Resetting the Function Selection Menu Settings
You can reset all the Function Selection Menu settings at a
time.
1
Press MENU/EXIT (or MENU on the
Monitor) to display the Main Menu.
2
Press 5/∞ to move the cursor (3) to
“FUNCTION SELECT.”
3
Press 3 to display the Function
Selection Menu.
*
1
“ASPECT” does not appear when 720/60p, 720/50p,
1080/60i (1035/60i), or 1080/50i signal is being input
through the COMPONENT/RGB B input terminals.
*
2
“SIGNAL MODE” appears only when VIDEO
A, VIDEO B, or COMPONENT input is selected.
*
3
“SYNC TERM.” appears only when the RGB B
input is selected.
4
Press 5/∞ to move the cursor (3) to
“reset.”
5
Press 3.
The confirmation screen appears.
6
Press 3 again to reset the adjustments.
To cancel the reset, press MENU/EXIT (or MENU on
the Monitor).
Are you sure?
"YES"
then key.
"NO" then key.
MENU
reset
Changing the Resistance of the RGB B
Input Terminals
You can set the resistance of the two of the RGB B input
terminals to either HIGH (1 kΩ) or LOW (75 Ω):
• HD/Cs (Horizontal sync/Composite) terminal
• VD (Vertical sync) terminal.
HIGH is the normal setting. Change the setting to LOW when
you use a long connecting cord and the picture flickers and
blurs on the screen.
1
Press MENU/EXIT (or MENU on the
Monitor) to display the Main Menu.
2
Press 5/∞ to move the cursor (3) to
“FUNCTION SELECT.”
3
Press 3 to display the Function
Selection Menu.
*
1
“ASPECT” does not appear when 720/60p, 720/50p,
1080/60i (1035/60i), or 1080/50i signal is being input
through the COMPONENT/RGB B input terminals.
*
2
“SIGNAL MODE” appears only when VIDEO
A, VIDEO B, or COMPONENT input is selected.
*
3
“SYNC TERM.” appears only when the RGB B
input is selected.
4
Press 5/∞ to move the cursor (3) to
“SYNC TERM.”
5
Press 2/3 to select the terminal
resistance.
Each time you press the button, the resistance alternates
between “HIGH” and “LOW.”
HIGH: Initial setting. Normally select this.
LOW: When using a long connecting cord and the
picture flickering and blurring on the screen.
6
Press MENU/EXIT (or MENU on the
Monitor) twice to exit the menu
operations.
PICTURE ADJ.
SIZE/POSITION ADJ.
FUNCTION SELECT
STATUS DISPLAY
ENTER:
MAIN MENU
SELECT:
EXIT:
MENU
Cursor (3)
COLOR TEMP.
ASPECT
SIGNAL MODE
COMPO./RGB B
SYNC TERM.
reset
FUNCTION SELECT
ADJUST:
SELECT:
EXIT:
MENU
: HIGH
: PANORAMIC
: AUTO
: RGB B
: HIGH
*
*1 *2 *3
PICTURE ADJ.
SIZE/POSITION ADJ.
FUNCTION SELECT
STATUS DISPLAY
ENTER:
MAIN MENU
SELECT:
EXIT:
MENU
Cursor (3)
COLOR TEMP.
ASPECT
SIGNAL MODE
COMPO./RGB B
SYNC TERM.
reset
FUNCTION SELECT
ADJUST:
SELECT:
EXIT:
MENU
: HIGH
: PANORAMIC
: AUTO
: RGB B
: HIGH
*
*1 *2 *3
14-21_GM_X50S.p65 04.3.2, 4:19 PM21