Filter
Top Products
Additional information
53
English
Additional
information
XV-C3SL / LET0213-001A / English
Troubleshooting
What appears to be a malfunction may not always be serious. Please go through the following list before
requesting service.
Symptom Possible case Remedy
Power does not come on. Power plug is not inserted securely. Plug in securely.
Remote control does not work.
Too far from the unit. More closer to the unit.
The tip of the remote unit is not
pointed in the right direction.
Point the infrared light- emitting
window toward the remote sensor on
the front panel.
Batteries are exhausted. Replace the batteries with new ones.
Battery polarity is incorrect.
Take out the batteries and insert them
again in the correct direction.
The TV/VIDEO - CANCEL,
CURSOR or numeric buttons do
not work.
The TV - DVD switch is not correctly
set.
To control the unit, set the TV - DVD
switch to “DVD.” To control your TV,
set the TV - DVD switch to “TV.”
No picture is displayed on the
monitor.
Connection of video cable is incorrect.
Connect the cable correctly.
Input selection of TV is incorrect. Select correctly.
Disc is not playable. Use a playable disc (see page 12).
Picture is not normal when
using the S-VIDEO jack.
The unit is set to feed the RGB
signals (instead of the S-video
signals).
Make the unit feed the S-video signals
(see pages 13 and 15).
Picture is noisy.
The unit is connected to a VCR
directly and the copyguard function
is activated.
Connect the unit so that the picture
signal flows directly to the TV.
No audio is reproduced.
Connection is incorrect. Check the connections.
Input selection of amplifier is
incorrect.
Select correctly.
No audio is reproduced when
playing back a DVD disc
recorded with 96 kHz, linear
PCM audio.
The audio signal is not derived
from the unit's DIGITAL OUT.
Use the AUDIO OUT when playing back
such discs.
Sound is distorted or noise is
generated.
Disc is dirty. Wipe the disc surface.
Picture does not fit the
television screen.
MONITOR TYPE is not correctly set.
Select monitor type correctly (see page 48).
Television is not correctly set. Set the television correctly.
Operation is not possible.
Microcomputer malfunction due to
lightning or static electricity.
Turn off the power and unplug the
power cord, then connect the power
cord again.
Moisture condensation caused by a
sudden change of temperature or
humidity.
Turn off the power, then turn it on a few
hours later.
;9&6/%B(QJERRN3DJH)ULGD\$SULO30