Filter
Top Products
12
Preparation
Note :
● Do not connect LAN1 to the internet. If the internet is busy
or the relay equipment fails, you may not be able to save
important camera images. To maintain full recording
capacity, it is recommended that a dedicated network be
used. Be sure to connect the LAN1 camera network to the
same segment. (Do not use the address translation of
NAT and NAPT etc. or a router.)
● If you connect LAN2 to the internet from a surveillance
computer, you will need to configure IP Masquerading.
● Communication between LAN1 and LAN2 is not possible.
Nor is it possible to configure a camera connected to
LAN1 from the surveillance computer connected to LAN2.
In order to configure a camera connected to LAN1, it is
necessary to connect the computer for configuring
cameras to LAN1.
● LAN1 and LAN2 are incompatible with QoS. Sound may
not be played normally depending on the condition of the
circuit.
● The default LAN1 IP address is 192.168.0.253 and the
default LAN2 IP address is 192.168.1.253. To change the
address, use [INSTRUCRTIONS].
● When a single network camera is registered with multiple
units of VR-N1600U/E, recording may not be properly
completed in some cases. Camera control (e.g. PTZ
control) may also become unstable. It is recommended
that a single VR-N1600U/E be used for registering one IP
camera as well as for controlling PTZ operations.
● Do not connect a broken hub, router or deteriorated
network cable etc. Doing so may prevent the system from
operating properly.
● Connection to a keyboard is not recommended.
Perform language setting and automatic camera registration
when starting up VR-N1600U/E for the first time.
Start up VR-N1600U/E
1 Turn on the power switch at the rear panel.
● VR-N1600U/E starts up.
System Connection
Example (continued)
During Initial Startup
Before Starting Up.
● The DHCP setting is required for the IP camera
beforehand. Start up the VR-N1600U/E first, then switch
the camera on after confirming that the [Auto Detect
Setting] window is displayed.
● Refer to the user manual supplied with the camera for
instructions on how to specify the IP camera settings.
● By default, [Time Zone] is set to [(GMT-05:00) Eastern
Time](VR-N1600U)/[(GMT) Greenwich Mean
Time](VR-N1600E) and [Auto Summertime Adjustment]
is checked. Specify a Time zone according to the region
used. Refer to the INSTRUCTIONS on how to specify a
Time zone settings.
OPERATE
RECCONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟
㧠
㧡
㧢*1/'
㧣
㧥
㧤
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCHFUNCTION ALARM CLEARKEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
Keypad
[SKIP]
Button
[KEY] Button
[16/ENTER]
Button
VR-N1600_Startup_EN_001B.book Page 12 Thursday, August 20, 2009 1:10 PM