Filter
Top Products
EN 7
INFORMATION
● If "AUTO CLOCK" is set to "ON" at the Clock Set screen on page 10, the clock will be adjusted automatically by the host
channel every hour on the hour (except for 11:00 PM, midnight, 1:00 AM and 2:00 AM) by the incoming PBS channel clock
setting data. (This automatic clock adjustment can only be performed when the VCR’s power is turned off. The clock will be
adjusted on the hour based on the time displayed on the VCR, not on the actual real time.) The default setting of "AUTO
CLOCK" is "ON".
● If the memory backup fails, because of a power outage or because the AC was removed from the VCR, Plug & Play will be
performed when power is restored to the VCR.
What To Do If Plug & Play Has Failed
● If an incorrect time is displayed on the front display panel, you may be receiving the clock setting data of a PBS channel from
an adjacent time zone, or an incorrect PBS channel from a cable TV system. In this case, perform the Semi-Auto (੬ pg. 10) or
Manual Clock Set (੬ pg. 11) procedure. Auto channel set has already taken place and it need not be set again.
● If “– –:– –” appears on the display, your antenna cable may not be connected to the VCR or there may not be a Host PBS
signal available in your area. Ensure that the antenna cable is connected correctly. Then power on and power off the VCR; the
Plug & Play function will be automatically reactivated and "Auto" will be displayed on the VCR's front panel. If Plug & Play is
not performed but the antenna cable is connected correctly, perform the Manual Clock Set procedure (੬ pg. 11). Auto
channel set has not yet taken place, so please also perform the “Set Receivable Channels” procedure (੬ pg. 12).