Filter
Top Products
Operating the Receiver
10
Operating the Receiver
In this chapter you will learn how to select TV and radio programs, set the required
volume and other options.
Switching on the equipment
• The equipment remains at ”Stand-by” as long as the voltage-supply is present.
• Use this remote control
button to switch from ”Stand-by” over to normal
operation, which is indicated by a red LED (light diode) in the infra-red sensor.
• The previously used channel will automatically be selected. (Last-status-
memory).
Switching between TV and Radio modes
You can receive either TV, analog or ADR radio programs with your receiver.
After switching on, the receiver will be in the same mode that was previously se-
lected (TV or radio) before it was switched off.
In TV mode the channel number display begins with a ”P” in the On Screen Display
(OSD) window. The screen is darkened when the radio modes are being used, and
the display begins in analog radio mode with ”R” and with ”A” in ADR radio mode.
• When using the remote controller you can switch between TV, analog and
ARD digital radio modes by pressing this button.
Operating sequence:
TV → analog radio → ADR radio → TV etc.
Channel Selection
• The required program may be directly selected by using these number
buttons.
Example of how to enter a three-digit number (”Select your program”):
To select program 147
• Enter 1, and program 1 is selected
• Enter 4, and program 14 is selected
• Enter 7, and program 147 is selected
or
• You may select the listed programs in consecutive order by using these
buttons.
After switching to another program, the channel number and name will be dis-
played on the screen for approx. 3 seconds.
Important When entering a 2 or 3 digit channel number the selected program will be switched
in after approx. 3 seconds. During this time other numbers may be entered.
When setting-up ”Select your program” the receiver will switch over automatically
to every channel number entered. (See the above example.)
When using the ”Basic Setting-up” menu a permanent window showing the se-
lected channel numbers may be set up (see section, ”Basic Setting-up, On Screen
Window”) for both TV and analog radio programs.