Filter
Top Products
Connecting and Setting-up the Receiver
9
Decoder Connection
You may also connect a Pay-TV decoder to the receiver by using a scart-cable.
When decoding, the video signal is used and the switching signal is present, i.e.
Premiere-decoder and video-encryption decoding, no other connection may be
made at the same time.
Important If no switching voltage has been supplied during decoding, the receiver must be
programmed as described earlier. (See chapter ”Setting-up TV programs”, section
”Video Menu”
• See the description in the decoder section as well!
• Use a scart-cable to connect the decoder to the decoder socket.
Installing batteries in the Remote Control.
• Remove the rear cover of the remote control.
• Insert the batteries into the remote control.
Ensure that the battery polarity is correct!
• Replace the cover.
Important Used batteries are hazardous waste! Do not throw your used batteries into your
dustbin, please take them your recycling centre or battery collecting bank.