Filter
Top Products
Basic Setting-up
25
Tone Burst and DiSEqC Signal
If a reception-system uses more than 4 control-criterions, then a DiSEqC control-
signal is required.
Which setting-up option, ”Tone Burst” or ”DiSEqC” is required depends upon the
components in your reception system.
Read the description of the fitted reception-system components (switching-matrix).
Tone Burst
The menu-option ”Tone Burst” allows the following settings for the 22 KHz signal:
Default switching status :
Default switching status:
22 KHz signal → High/Low and
Tone Burst → Pos. A/B:
22 KHz signal → Pos. A/B and
Tone Burst → Opt. A/B
Low
High
22 KHz Off
On
Pos. Tone Burst 22 KHz
Pos. 1
Pos. 2
Tone Burst
Tone Burst
0
1
1
2
3
4
0
0
1
1
Off
On
Off
On
DiSEqC
With the DiSEqC-Signal, the switching options are again enhanced
To ensure a perfect setting-up, you must know the reception-system switching-
criterions.
Read the description of the DiSEqC-matrixes and contact your qualified reception-
system technician.
DiSEqC Repeat
The DiSEqC command must be repeated if the satellite reception-system contains
cascaded "DiSEqC components" (DiSEqC matrixes consecutively switched).
• Switch the menu option "DiSEqC repeat" to "On".
Remote
The setting ”Remote” in menu-option ”DiSEqC” is for planned future modifications.
If the receiver UFD 346 is connected to a reception-system with a ”subscriber con-
trolled signal processing system e.g. ”Kathrein UFO mini digital ”, then Remote
must be selected from the DiSEqC menu.
In this case the corresponding upper carrier frequency in the range 920 - 2150
MHz must be selected from the menu option ”Remote Frequency”. With this fre-
quency the satellites signals are transferred from the reception-system to the re-
ceiver.
• Press this button twice, to save your settings.
• Press this
button twice, to exit the basic setting-up menu.
Important The settings will be lost if you exit the menu without saving!