Filter
Top Products
Basic Setting-up
26
"EEPROM" Menu Option
The menu option "EEPROM" is provided so that the service technician may read
the program data in and out.
Remote Control Command Set Switching
The remote control includes 2 sets of command instructions. Therefore it is possi-
ble to operate 2 independent 200 and 300 series satellite receivers in a room with
only 1 remote-controller. (not applicable to a Twin-receiver).
Program the first receiver to work with command set 1, and second receiver with
command set 2.
• Switch receiver 1 on and receiver 2 off (using the units ON/OFF switch).
− Press and hold down this button.
− Using the number buttons enter ”001”.
• Switch receiver 1 off and receiver 2 on (using the units ON/OFF switch).
− Press and hold down this button.
− Using the number buttons enter ”002”.
• Switch receiver 1 back on.
− Press and hold down this button.
− Using the number buttons enter ”003”.
Important With the first pair of settings, the remote controller is set to switch to the required
receiver.
With this button you can switch between the two command sets A & B (tog-
gle mode) and therefore alternate between and operate both receivers.
When delivered from the manufacturer, command set 1 is the default mode.
Important If you are using only one receiver and due to an operating error the system has
switched out of the default operating set, so that you no longer have control of the
receiver, the remote controller may be easily switched back over to the correct
command set 1. How to achieve this is described above.