Filter
Top Products
Receiver operation
11
VOL 18
Note
The settings are not effective on the VCR Scart socket in order not to disturb any
recordings.
The on-screen display is removed again after approximately 3 seconds.
Whilst the menu for volume adjustment is overlaid, the
key can be used to acti-
vate the following menu for balance adjustment, tone adjustment, stereo width and
pseudo-stereo .
LED-Display Indicator:
VOL 00
BAL 00
TREB 00
BASS 00
WIDTH 00
PSEU OFF
Using the
keys or the key you can select the particular menu entry and
then make changes with the
keys.
Note
In the menu entry “Stereo Width" the stereo base width can be adjusted independ-
ently.
“Pseudo-Stereo" can be used to simulate a “stereo-like“ effect with mono pro-
grammes, and should thus only be activated with mono reception.
If Pseudo-Stereo has been turned “On“, the stereo width can no longer be altered.
Muting the sound
•
Press the
key.
The sound is muted, allowing you to make a phone call undisturbed, for example.
In the LED display the sound muting is displayed with dots
. . . . . . . .
•
Press the
key again to turn the sound back on.
Note
Mute is not operative on the VCR Scart socket.
Stereo- / Mono- / Channel changeover
TV broadcasts can be transmitted in the two-tone channel method
(e.g. original tone “English" on channel 1, “German" tone on channel 2).
•
Press the key. Each time you press the key, you switch the sound channel in
the order:
Channel 1 → Channel 2 → Stereo .
The selected channel is shown on the screen and in the LED display. The setting is
not saved. After a change in programme the original setting takes effect again.
SAT/TV changeover
Where the satellite receiver and TV set are connected via a Scart cable, many TV
sets immediately switchover signal input (on the Scart socket) to video reception
when the satellite receiver is turned on um. The switching voltage of the TV Scart
socket therefore needs to be switched off if you want to view a terrestrially broad-
cast TV programme.
•
Press the
key.